I could use some advice here. Symptoms are, during an Y-axis move say, g1 x1 (inch), will work just fine,
a second g1 x1 move will also work fine. But a reversal to g1 x-1 will result in a very brief pause during
the move. On each reversal (either direction) the pause occurs. There is no chattering (like it has hit an
end stop) or other unusual noise that I can here. It results in about 1/8" backlash.
The machine is a SolSylva 25" x 25" that I just recently put together. The axis this...
Hiccup (skipped steps??) on Y Axis
a second g1 x1 move will also work fine. But a reversal to g1 x-1 will result in a very brief pause during
the move. On each reversal (either direction) the pause occurs. There is no chattering (like it has hit an
end stop) or other unusual noise that I can here. It results in about 1/8" backlash.
The machine is a SolSylva 25" x 25" that I just recently put together. The axis this...
Hiccup (skipped steps??) on Y Axis