Quantcast
Channel: OpenBuilds
Viewing all articles
Browse latest Browse all 6775

Meltdown!

$
0
0
Opinions ar sought, but I believe I just found out what happens when the TinyG over heats! Did not seem like I was loading it up, but it ran the first job (on the left), had ten or fifteen minutes idle, then started the second job, about 15 minutes into the first cut and she went ape-shit! The TinyG is out in the open, in a room I have to heat, would not have thought it would get hot?!? Anyone have any ides? As you can see, it didnt just loose steps, it took off on its own! I WILL be putting...

Meltdown!

Viewing all articles
Browse latest Browse all 6775

Trending Articles